Print Page - Apogge 12 pin

Title: Apogge 12 pin
Post by: dan434 on February 20, 2004, 12:21:28 PM

I have been having some issues with my 12-pin of late for my ad1k. The unit powers on just fine & I can get a signal via aes/ebu cable but I cannot get one from the coax/rca coming out of the 12-pin. Could this short out and need to be re-wired or is my cable just shot all together?? Any input would be great, thanks!

Title: Re:Apogge 12 pin
Post by: cpclark on February 20, 2004, 05:04:54 PM

i have an extra one that i dont use anymore that went with my ad500e if you want that for a couple of bucks

Title: Re:Apogge 12 pin
Post by: Chuck on February 20, 2004, 05:22:33 PM

If you go to the Apogee site, they have a pin-out drawing for that connector.
If you have a multi-tester it would be easy to figure out if the problem is in the cabling by checking continuity.

Title: Re:Apogge 12 pin
Post by: Lee on February 20, 2004, 06:03:57 PM

I can sell you one of mine if you want it, since no one will buy my ad500...

Title: Re:Apogge 12 pin
Post by: THE NIZ BIAAAAACH! on February 21, 2004, 01:11:40 AM

What calico said you can always re wire your 15pin the important part is that you have the actuall15 pin in tact.

Title: Re:Apogge 12 pin
Post by: Lee on February 21, 2004, 02:21:26 AM

you can get the 15-pin DSUB connectors at the shack for about 3 bucks FWIW

Title: Re:Apogge 12 pin
Post by: Jason B on February 21, 2004, 11:57:12 AM

Hey, I can make these really easily if anyone needs one.

Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: dan434 on February 20, 2004, 12:21:28 PM