Text only | Text with Images

Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: jbell on October 26, 2011, 04:50:53 PM

Title: Can anyone with a schoep VMS pre help out???
Post by: jbell on October 26, 2011, 04:50:53 PM
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground.  While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.

Any help would be greatly appreciated!!  TIA
Title: Re: Can anyone with a schoep VMS pre help out???
Post by: F.O.Bean on October 26, 2011, 05:13:17 PM
For what? You building a VMS? :P ;D
Title: Re: Can anyone with a schoep VMS pre help out???
Post by: hi and lo on October 26, 2011, 05:19:43 PM
Quote from: F.O.Bean on October 26, 2011, 05:13:17 PM
For what? You building a VMS? :P ;D

Sort of...
Title: Re: Can anyone with a schoep VMS pre help out???
Post by: F.O.Bean on October 26, 2011, 10:50:03 PM
Quote from: hi and lo on October 26, 2011, 05:19:43 PM
Quote from: F.O.Bean on October 26, 2011, 05:13:17 PM
For what? You building a VMS? :P ;D

Sort of...

I'll take one then :) ;D
Title: Re: Can anyone with a schoep VMS pre help out???
Post by: StuStu on November 02, 2011, 01:43:09 PM
Quote from: jmbell on October 26, 2011, 04:50:53 PM
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground.  While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.

Any help would be greatly appreciated!!  TIA


VMS02IB manual in PDF was posted by gmm6797 in this thread: http://taperssection.com/index.php?topic=57349.msg753909#msg753909 (http://taperssection.com/index.php?topic=57349.msg753909#msg753909)
Title: Re: Can anyone with a schoep VMS pre help out???
Post by: jbell on November 02, 2011, 04:34:58 PM
It's not needed anymore, problem solved

Quote from: StuStu on November 02, 2011, 01:43:09 PM
Quote from: jmbell on October 26, 2011, 04:50:53 PM
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground.  While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.

Any help would be greatly appreciated!!  TIA


VMS02IB manual in PDF was posted by gmm6797 in this thread: http://taperssection.com/index.php?topic=57349.msg753909#msg753909 (http://taperssection.com/index.php?topic=57349.msg753909#msg753909)
Text only | Text with Images