Print Page - HPF options on the Lunatec V3?

Title: HPF options on the Lunatec V3?
Post by: One Cylinder on December 15, 2011, 04:37:20 PM

I can't tell from the V3's owner manual -- which set of specs apply to a stock V3?

HPF SWITCH POSITION and CUTOFF FREQUENCY:

1 = 100Hz
2 = 50Hz

OR

1 = 125Hz
2 = 75Hz

Thanks...

Title: Re: HPF options on the Lunatec V3?
Post by: page on December 15, 2011, 04:39:49 PM

they both do, it's controlled via switchable jumpers inside the unit

Title: Re: HPF options on the Lunatec V3?
Post by: One Cylinder on December 16, 2011, 02:32:03 AM

......should have been more clear - when the V3 leaves the production floor, to which specs are the jumpers set?

Title: Re: HPF options on the Lunatec V3?
Post by: Brian Skalinder on December 16, 2011, 02:50:31 AM

Only way to know for certain how your unit was configured on the production floor: open it up and check the jumpers. It's very easy to do, and as long as you don't mess around with anything inside, you can't hurt it.

Title: Re: HPF options on the Lunatec V3?
Post by: F.O.Bean on December 17, 2011, 12:51:00 AM

When new, theyre at 50/100

Title: Re: HPF options on the Lunatec V3?
Post by: One Cylinder on December 23, 2011, 01:12:54 PM

.....Thanks Bean. That was a tough one! ;D

Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: One Cylinder on December 15, 2011, 04:37:20 PM