Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: Mikel on October 01, 2012, 06:02:23 PM
-
I tried to search for this topic but no luck.
What's a good replacement for the black plastic ring/washer between the capsule and body on a Nak 300?
Thanx
Mike
-
I don't have a good answer to your question, but I just ran without them... screw it down until it stops, don't crank the hell out of the threads, and there will be a little gap.
-
That's what I've been doin' so far. Was hoping to hear about a quick fix.
Thanx much
-
need something mechanical made ican help. have a cnc machine shop. finally ready to make active cable ends for a bunch of different mics.
-
Poke around in the faucet part drawer at Lowes or your hardware store.
There are O-rings and other nylon rings that can do the job.
-
Cool...I'll give it a try.
-
There are O-rings and other nylon rings that can do the job.
Yes, o-rings about 20x1 mm, could do the trick.
-
need something mechanical made ican help. have a cnc machine shop. finally ready to make active cable ends for a bunch of different mics.
!
-
I tried to search for this topic but no luck.
What's a good replacement for the black plastic ring/washer between the capsule and body on a Nak 300?
Thanx
Mike
Put a ISO on the Nak Team Thread....there are folks whom modify these and may have one laying around.
need something mechanical made ican help. have a cnc machine shop. finally ready to make active cable ends for a bunch of different mics.
!
If we could only get the guts to put into it...right Chuck