Which would be the best of these 3 recorders (r09hr, dr07, dr2d) to plug into a soundboard? I'm going to a show this weekend and will plug one into soundboard, and run 2 audience. thx in advance.
Quote from: daze on November 22, 2012, 08:09:13 PM
Which would be the best of these 3 recorders (r09hr, dr07, dr2d) to plug into a soundboard? I'm going to a show this weekend and will plug one into soundboard, and run 2 audience. thx in advance.
They should all sound fine. The advantage of using the DR-2D would be that you could run a matrix with one set of mics and the soundboard. I believe that you'll probably need an attenuator between the SBD and the Tascam though.
The R-09HR takes the hottest signal (I think I am correct there).
M10 looks better according to these tests!
http://www.avisoft.com/recordertests.htm
Quote from: yates7592 on November 23, 2012, 03:48:59 AM
The R-09HR takes the hottest signal (I think I am correct there).
Quote from: jbell on November 23, 2012, 10:05:03 AM
M10 looks better according to these tests!
http://www.avisoft.com/recordertests.htm
Quote from: yates7592 on November 23, 2012, 03:48:59 AM
The R-09HR takes the hottest signal (I think I am correct there).
Yes, but the OP doesn't have one of those!
Your right! My bad.
Quote from: yates7592 on November 23, 2012, 10:19:34 AM
Quote from: jbell on November 23, 2012, 10:05:03 AM
M10 looks better according to these tests!
http://www.avisoft.com/recordertests.htm
Quote from: yates7592 on November 23, 2012, 03:48:59 AM
The R-09HR takes the hottest signal (I think I am correct there).
Yes, but the OP doesn't have one of those!
thx - so if i'm reading the chart right (which I'm not sure I am) i'd be best off using the r09hr on the sbd? thx for your help!
I just ran SBD>M10 Weds night, and it couldnt have been ANY EASIER ;) Line-In, with gain level at about 3, and peaks at -10db. PERFECT IMO!
Of the three mentioned, I'd choose the R-09HR for recording SBD alone, becasue it should be able to handle a hotter signal without overloading if that happens to be necessary. Any of the three will work given a good level out of the board. Ive used both original R09s and DR2ds and have not had a problem with either.
thanks! You all are the best. I will run my r09hr off the soundboard, and will use the other two recorders for audience. I realize now I need to buy an attenuator cable for the future (but that won't help me tonite lol).