Taperssection.com
Gear / Technical Help => Post-Processing, Computer / Streaming / Internet Devices & Related Activity => Topic started by: IceMan on May 06, 2013, 09:20:08 PM
-
I installed everything for my new M10 and tonight I was just trying to convert over to CD what I had ripped (both for a buddy and for me to sorta listen to in car and critique)
After a few hours now I still don't have a disc. Conversion to computer was fine. Right now I am not looking for fades and all that, just want to convert. I used the t-mark to break up tracks so I see that in the software.
It is going to take 2 cds...so I "highlight" about 50 minutes at first.
1. I can't burn to DAO, only TAO. Its low lit, and I can't change it
2. Just wanting to get a result I say TAO
3. THe small burn box appears and the speed I see is 4x. I keep getting a message that its "too fast" for my computer. Again, just wanting some success I try to lower it..but can't. It says it failed due to a buffer over run.
Anyone have any ideas?
One other thing, since I t-marked it does it now to "burn tracks"?
I feel pretty stupid right now. Appreciate any advice. Or, is there a better/easier way?