Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: silentmark on June 02, 2004, 01:30:59 PM
-
Has anyone received static on their recordings when adjusting the left or right channel gains ?
The last few tapes I pulled I noticed some static and I know it is when I adjusted the gain. I have never had this happen before. Anyone else ?
It also seems at times as if I get a channel level flux while adjusting, almost like a headphone jack not all the way plugged in, then you plug it in and you get the fullness, that's the best way I can describe it.
Any help would be greatly appreciated...
-
see if you can get a can of air (RATSHACK) and clean out the dirt......
-
i owned an sxm2 for a short while and mine had this problem.
i unloaded it before i could diagnose and fix... stealthed once with a loaner mp2 and haven't looked back since.
-
see if you can get a can of air (RATSHACK) and clean out the dirt......
Ya know I was thinking the same thing, just cause I never had this happen before so I don't think it is an electronic issue ... +T
-
I think CBD had this issue with his a couple years ago. you should ask him what he did to fix it
-
i think you need to sell it fast before it gets to be too bad, email this guy...
Trey.Woodruff@l-3com.com
He can help you unload it
-
I think CBD had this issue with his a couple years ago. you should ask him what he did to fix it
'scuse my ignorance, but who is CBD ?
-
i think you need to sell it fast before it gets to be too bad, email this guy...
Trey.Woodruff@l-3com.com
He can help you unload it
Heh, yeah I prolly should dump it before I figure out what is up. At a discount of course cause it has problems ... ::) ;)
-
I think CBD had this issue with his a couple years ago. you should ask him what he did to fix it
'scuse my ignorance, but who is CBD ?
craig davis..his handle on this board is cbd