Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: airbladder on July 05, 2004, 02:08:35 PM
-
I just got a pair of hypers and was wondering what kind of configurations work best.. Up until now I have used cards. Do you point each mic just out side the stack? Run them 20cm 60-100 degrees? How is it different than cards? Any help would be great.
Mbho ka200n/500n 648a> V2> Minime> DA-P1/JB3
-
Some people like hypers ~7" (17cm) @ 90* (DINa?)
I like them ~8"(20cm) @ 70-80* or XY @ 70-80*
-
Some people like hypers ~7" (17cm) @ 90* (DINa?)
I like them ~8"(20cm) @ 70-80* or XY @ 70-80*
I'd run 'em 17 cm at 90 deg (DINa) the 20cm spacing is for the cards and is suppose to get a hole if you use hyprs in the card setting...don't know cause I didn't try to make any image holes... BUT to each their own...it's all a starting point and what your ears like. check out the Oade site http://www.oade.com/Tapers_Section/faq-mic.html may give you some more info.....
so how did you run your cards?
peace
jah
-
I'm not big on configurations with my hyper's in most venues -- except for PAS. (Point at Stack)
-
I run mine in DIN all the time. Only exception is when I'm very far off center and I run pointed at the stack, but that is very rare.
-
i also have ran my TL's- hyper & DIN
-
i also have ran my TL's- hyper & DIN
Ever try them coincident....it has been said that LD's sound their best when run coincident...it's a little harder to align the cap over each other but is suppose to be more focused. GIve it a try and let us know ;)
peace
jah