Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: michael on July 16, 2004, 02:29:57 PM
-
Well I sold my mics and want to tape a band tonight and I know I can get a board patch, sould I hook up my ad/20 then connect the d100?or just go straight to the dat from the board?, how do I connect to the board, its analog and i am just wondering about cables
thanks
michael
-
sbd>dat
no need for the ad20 as it has a gain stage.
edit: cable >>> depends on the outs on the board you'll need either dual rca>stereo mini or dual 1/4'>stereo mini
-
HMMMMMMMM...SOLD YOUR MICS. tsk tsk tsk ---- and you wanna be team memphis
the board will either have rca outs or xlr outs or maybe even 1/4 inch (female)
-
HMMMMMMMM...SOLD YOUR MICS. tsk tsk tsk ---- and you wanna be team memphis
the board will either have rca outs or xlr outs or maybe even 1/4 inch (female)
Hold on Tommy, I am upgrading (TL's ;D), within the month
-
sbd>dat
no need for the ad20 as it has a gain stage.
edit: cable >>> depends on the outs on the board you'll need either dual rca>stereo mini or dual 1/4'>stereo mini
line in or mic in?
-
line in
TL's --- what about a man's mic (AKG)
-
line in
TL's --- what about a man's mic (AKG)
they're too small, I've got a complex and need BIG mics ;D
-
I understand
Andy uses them and they sound effen great ;D
-
Ok Sorry I'm new to the SBD patches thing..I have a question..
I have a Sharp MD-MT99 and was going to a few shows this summer, and some of the bands might allow Soundboard patches, if so, what cables do I need to plug into the SBD?
I have Line Out, Line In, Mic In, etc on my MD.
Thanks for your help..
Joe.
-
what cables do I need to plug into the SBD?
Check the Cables forum for a post answering your question.
-
more than cables,..... patience!
I'm all but sworn off that gawddamn noise making, flat sounding, p.o.s. for good!!
sbd's suck :-X
sounds like yesterday didn't go so well... :P
-
ouch!
i had no idea it got that ugly...
those security cats were pricks, though...
was the scientist doing the sound for the decond act?
did you have better luck from the 'board with ras' set..?