Could someone gime me the poop on the NJB3's meters? They aren't really marked, I have too little time to test out the finer points of deciphering the levels from those meters. Running v1.40.06p
Thanks,
ANDY
well, it is hard to be very specific, but about 1/2 way is -12, just below the top section is -3 and if it goes into the top section, you're over.
With the -3 light blinking slightly on my ua-5 I get perfect levels on the jb3.
JAson
Score a SVU-1 here at this link brought to you by the friendly taper community! It well save you alot of head aches later.
http://www.taperssection.com/yabbse/index.php?topic=19556.0
Quote from: bhtoque on September 01, 2004, 11:30:12 PM
well, it is hard to be very specific, but about 1/2 way is -12, just below the top section is -3 and if it goes into the top section, you're over.
With the -3 light blinking slightly on my ua-5 I get perfect levels on the jb3.
JAson
This is exactly the same deal for me. I actually run it a little hotter than this.
TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...
I had mine hooked up to a sony pro DAT dig out...the delay was visually obvious...the peak would occur on the Sony before it showed on the JB3
rely on your A/D for metering not the jb3
Quote from: hexyjones on September 02, 2004, 11:00:40 AM
TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...
I had mine hooked up to a sony pro DAT dig out...the delay was visually obvious...the peak would occur on the Sony before it showed on the JB3
Of course it's not a scientific test or anything, but with a d8 on the coax of the ua-5 and the jb3 on the optical they seemed in synch.
hard to watch both at the same time though.
+t to you for having sharper eyes than me.
JAson
Quote from: hexyjones on September 02, 2004, 11:00:40 AM
TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...
Q4T
mosdef not in sync with the sbm-1 over light