Taperssection.com
Gear / Technical Help => Cables => Topic started by: Zaphod on October 14, 2004, 08:45:08 PM
-
Searched to no avail, just wonering if there is a standard schematic to wire such cable.
I know to make sure that the sleeve of the 1/4" inch is to be wired to the pin 1 for ground, but what about the other pins? I suppose it shouldn't matter as long as the ground is right?
Thanks.
-
http://www.montarbo.com/pdf/connettori.pdf
Tip: Pin 2
Ring: Pin 3
Shield: Pin 1
marc
-
Printed that one out, thanks a bunch Marc, and +T.