Taperssection.com

Gear / Technical Help => Ask The Tapers => Topic started by: Low Spark on December 04, 2004, 03:12:51 PM

Title: Mixers
Post by: Low Spark on December 04, 2004, 03:12:51 PM

I would like to get an inexpensive mixer to start pulling some matrix in the future.  What would be a good one.  Behringer Eurorach UB1202 or MX802A. Have been looking at these on Ebay. Thanks for the help

Title: Re: Mixers
Post by: fsulloway on December 04, 2004, 03:21:29 PM

I use a Mackie 1202 vlz pro which I got on ebay for about $150. So far it's been great. Behringer does have a model which runs off batteries though which could be useful.

Title: Re: Mixers
Post by: nickgregory on December 04, 2004, 03:26:16 PM

mxb1002 runs off batts, but only provides 15V phantom when run off batteries.  Not a big deal though, you should definitely run a good pre in front of it as the pre in the unit is noisy

Title: Re: Mixers
Post by: hexyjones on December 04, 2004, 07:54:23 PM

I've been pretty happy with this small Yamaha mixer...needs AC though and adds a bit to your carry in...

Pretty flexible though...and if you happen to be a musician, you can use it those endeavors as well...

http://www.yamahaproaudio.com/products/mixer/a_mixer/mg_series/mg10_2/

4 mic ins...48V phantom...extra two track ins...

You can even run two discrete sets of mics and make two seperate recordings...with the right cables...

I havent listend to enough preamps to compare this sonically to anything...

I paid $99.00

Title: Re: Mixers
Post by: urobouros on December 06, 2004, 11:02:34 AM

You might check out the Mixpad 4:

http://www.samsontech.com/products/productpage.cfm?prodID=66&brandID=2

It only provides 18V phantom unles you make the jump to the Mixpad 9 or 12 and you get 36V.  You can usually find them for <$75 at ebay.