Taperssection.com

Gear / Technical Help => Post-Processing, Computer / Streaming / Internet Devices & Related Activity => Topic started by: millhouse412 on January 28, 2005, 12:41:49 PM

Title: edirol ua-5 > soundforge help???
Post by: millhouse412 on January 28, 2005, 12:41:49 PM
So i am running my DAT to my computer through the USB in my UA-5 to Soundforge 6.0.

Question...

The recoding level green bar things in soundforge, should i try to keep these low or high or in the middle?? so basiclly how to adjust the output level from teh UA-5 when recording to soundforge....High or low...which is better
Title: Re: edirol ua-5 > soundforge help???
Post by: rerem on February 01, 2005, 04:52:57 AM
Levels should be on the high end but don't clip. SF has undo,find a loud section and if you get too close to the top/clipping or the red clipping thing shows up,stop,undo,lower the level
Title: Re: edirol ua-5 > soundforge help???
Post by: Brian Skalinder on February 01, 2005, 09:15:49 AM
If you're sending a digital signal from your DAT through the UA5 to your PC via USB:


Then you don't need to - can't - adjust the levels in Soundforge.  If you're running the DAT into the UA5 via an analog signal:


Spend a few bucks on a 7-pin / coax cable so you can do digital transfers!  If that's not an option, set your peak levels using the UA5 and - since the UA5 has a single light for indicating peak levels - use Soundforge to monitor L/R balance.