Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: braweave on June 22, 2005, 01:11:48 AM

Title: ua-5 question.
Post by: braweave on June 22, 2005, 01:11:48 AM
can you record simultaneously from the ua-5 via both the optical and the coax outputs??

or do you have to choose between the 2??

thanks
Title: Re: ua-5 question.
Post by: bhtoque on June 22, 2005, 02:14:41 AM
can you record simultaneously from the ua-5 via both the optical and the coax outputs??

or do you have to choose between the 2??

thanks

It's digital or analog in, not both at the same time. So you could not mix mics and a digital feed for a matrix.

JAson
Title: Re: ua-5 question.
Post by: blu666z on June 22, 2005, 02:32:23 AM
I'm pretty sure that both the coax and optical outputs are active at the same time.

-Kevin
Title: Re: ua-5 question.
Post by: terrapinj on June 22, 2005, 02:21:02 PM
there is a switch on the back to choose either optical or coax. so i believe you can only use one or the other, but I have never tried to run coax so I could be wrong
Title: Re: ua-5 question.
Post by: Brian Skalinder on June 22, 2005, 02:24:16 PM
Check the Archive | Pres/ADCs/Processors forum's UA5 FAQ.
Title: Re: ua-5 question.
Post by: twatts (pants are so over-rated...) on June 22, 2005, 03:39:48 PM
I'm pretty sure that both the coax and optical outputs are active at the same time.

-Kevin

This is correct, or rather, ALL the outputs work all at once.  The Coax and Optical output what the USB would normally output - part of the digimod...  The analog outputs work, but make sure to dial output volume to max.  Make sure Monitor light is OFF, or you are looping the analog signal through and gettig an echo.

T

Title: Re: ua-5 question.
Post by: blu666z on June 22, 2005, 04:14:32 PM
there is a switch on the back to choose either optical or coax.

This only applies input.

-Kevin
Title: Re: ua-5 question.
Post by: drewloo on June 22, 2005, 11:25:50 PM
can you record simultaneously from the ua-5 via both the optical and the coax outputs??

or do you have to choose between the 2??

thanks

Yes, I run a D8 (coax) and a JB3 (optical) out of a UA5 all the time.