Print Page - Sabra Som ST2 (need ST4 length)

Title: Sabra Som ST2 (need ST4 length)
Post by: audBall on December 29, 2005, 01:18:32 PM

Is it possible to get these hex rods aftermarket? The length of the ST4(or even longer) would come in real handy and I'd rather not fork the money for a new mount just to get the rod.

Title: Re: Sabra Som ST2 (need ST4 length)
Post by: RebelRebel on December 29, 2005, 02:22:42 PM

Quote from: Audßall on December 29, 2005, 01:18:32 PM
Is it possible to get these hex rods aftermarket? The length of the ST4(or even longer) would come in real handy and I'd rather not fork the money for a new mount just to get the rod.

I think I might can help Horus..pm sent

Title: Re: Sabra Som ST2 (need ST4 length)
Post by: audBall on December 29, 2005, 03:05:50 PM

Well, I measured the ST2 hex bar to 0.375" with a cheap tape measure.

Found this site:
http://www.onlinemetals.com/merchant.cfm?id=13&step=2

I think it just may do the trick. Much cheaper option than buying another mount.

They also have aluminum which is considerably cheaper. I think I'll stick w/ the stainless.

Title: Re: Sabra Som ST2 (need ST4 length)
Post by: Chuck on December 29, 2005, 07:04:21 PM

I remember seeing various lengths available. The Soundroom maybe ???

Taperssection.com

Gear / Technical Help => Microphones & Setup => Topic started by: audBall on December 29, 2005, 01:18:32 PM