Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: run_run_run on October 15, 2006, 11:16:02 AM

Title: un diging a UA-5.
Post by: run_run_run on October 15, 2006, 11:16:02 AM

I tryed to digi my UA-5 and I cut the trace and can't handle the wire part. To make it work in the meantime with my laptop due I need to fix the cut trace?

Title: Re: un diging a UA-5.
Post by: Ryan Sims on October 15, 2006, 12:20:42 PM

It should still work, if I remember correctly.

Title: Re: un diging a UA-5.
Post by: run_run_run on October 15, 2006, 12:35:47 PM

Quote from: Ryan Sims on October 15, 2006, 12:20:42 PM

It should still work, if I remember correctly.

odd, my computer does not see it when I hook the USB up.

Title: Re: un diging a UA-5.
Post by: run_run_run on October 15, 2006, 03:04:45 PM

I tryed it with a few machines and nothing. Is there a chance its dead?

Title: Re: un diging a UA-5.
Post by: Ryan Sims on October 15, 2006, 04:39:48 PM

Will it pass an analog signal?

Title: Re: un diging a UA-5.
Post by: willndmb on October 15, 2006, 04:46:41 PM

you might still need the jumper in order for it to work, not sure though

Title: Re: un diging a UA-5.
Post by: J.T.L on October 15, 2006, 06:15:00 PM

http://www.intertronics.co.uk/products/tec2505.htm

...to remake the trace.

Title: Re: un diging a UA-5.
Post by: run_run_run on October 16, 2006, 11:25:46 AM

Quote from: J.T.L on October 15, 2006, 06:15:00 PM

http://www.intertronics.co.uk/products/tec2505.htm

...to remake the trace.

yeah thanks