Taperssection.com
Gear / Technical Help => Remote Power => Topic started by: Jhurlbs81 on January 16, 2007, 10:25:30 PM
-
So with the uprgade to the 2k, I must replace my lead with Li-Ion. What's my best bet? My V3 is currently set to 6v. Two DVD batts? One for each? I see a 5400mAH can be had for 40 beans..
Jesse
-
What's the volatage on the 2K? The V3 is either set to run on 6 or 12V. It really is the same, it's just a calibration inside so that the low battey indicator works. You may also want to check out this thread http://taperssection.com/index.php/topic,78206.0.html
I have been running a V3 on one of the 9V Wallys, and it is running fine, and according to that thread, is not an issue. Need to know what the 2K needs to run.
-
The AD2k is 12V. Two of the DVD batteries in series would work if they have a 6V setting otherwise you could use a voltage regulator to drop the 18V down to 12V.
Joe
-
The AD2k is 12V. Two of the DVD batteries in series would work if they have a 6V setting otherwise you could use a voltage regulator to drop the 18V down to 12V.
Joe
The AD2K+ will run on any voltage between 12v - 18v. So any Li-ion in that range will work.
-
I would consider getting your V3 reset to 12V, instead of 6, and that way you can have just one battery system to contend with.
-
Ballpark ideas on total batt life with a V3 & AD2k running off a EC-90?
Thanks,
Jesse