Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: jhirte on November 22, 2003, 05:26:59 PM
-
Anyone know where I can get some for a reasonable price?
figure I can either do mebby 1.5 ft for what I need, or just get some 15ft'ers.....
thx
-Jim
-
make them man,get some connectors, and cable, solder them together. and your good to go. if you can't someone here will.. i could do it, i'd have to get the stuff, but i could do it. but there are others here that make cables for people.. ask around..
matt
-
Anyone wanna help me out? I'll pay for parts and your time.
-Jim
-
You can do this yourself. I know it sounds intimidating, but I swear it's not that bad. I made a set of 3"-5" cables w/right angle XLRs. It's no big deal, and once you get used to it you'll never pay $50+ for a good cable again!
There are some tutorials in the archives here. You can get the parts at www.markertek.com. The right angle Neutriks are a little pricey, but that's all relative. You might spend $15 for a short cable. Expect $5.50 or so for right angles, $1.50 or so for standards. Canare star quad is $0.34/foot sold in 1 foot intervals.
Give it a shot, you'll be glad you did!
Chuck
-
you talked me into it. heh actually I figured what the hell, and ordered up stuff about an hour ago.
Canare quads, a few sets of Neutrik black w/Silver plugs.. right angles, etc..
Rokken!!!
-
you talked me into it. heh actually I figured what the hell, and ordered up stuff about an hour ago.
Canare quads, a few sets of Neutrik black w/Silver plugs.. right angles, etc..
Rokken!!!
if they haven't shipped yet you might want to look into spending a couple extra dollars to get the gold connections instead.