Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: PCM R300 > opti > D50 ?  (Read 2660 times)

0 Members and 1 Guest are viewing this topic.

Offline ethan

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4305
  • Gender: Male
  • Go Buffs!
    • COTapers.org
PCM R300 > opti > D50 ?
« on: August 13, 2011, 02:15:49 PM »
Trying to transfer some old dats. Would PCM R300 > opt > D50 be a clean transfer?
« Last Edit: August 13, 2011, 03:59:00 PM by ethan »
Logged
COtapers.org - "We're higher than your average taper"

Offline Todd R

  • Over/Under on next gear purchase: 2 months
  • Trade Count: (29)
  • Needs to get out more...
  • *****
  • Posts: 4902
  • Gender: Male
Re: PCM R300 > opti > D50 ?
« Reply #1 on: August 13, 2011, 03:00:44 PM »
Sounds like a good plan E. I transfer all the time with the same path, except I use an A6 which is a consumer SCMS version of the 300.
Logged
Mics: Microtech Gefell m20/m21 (nbob/pfa actives), Line Audio CM3, Church CA-11 cards
Preamp:  none <sniff>
Recorders:  Sound Devices MixPre-6, Sony PCM-M10, Zoom H4nPro
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.032 seconds with 26 queries.
© 2002-2025 Taperssection.com
Powered by SMF