Become a Site Supporter and Never see Ads again!
Previous topic - Next topic
Pages: Pages1   Go Down

Author Topic: Church UBB battery contact not snug  (Read 6,785 times)

0 Members and 1 Guest are viewing this topic.

Offline beatkilla

  • Trade Count: (83)
  • Needs to get out more...
  • *****
  • Posts: 2,331
Church UBB battery contact not snug
« on: April 21, 2015, 04:33:41 PM »
Anyway to resolve this?The negative part on Ubb is not a good fit,the 9 volt easily disconnects but stays fit on positive side.
Logged

Offline jagraham

  • Trade Count: (21)
  • Needs to get out more...
  • *****
  • Posts: 3,105
Re: Church UBB battery contact not snug
« Reply #1 on: April 21, 2015, 04:38:21 PM »
Owned 3 UBBs and never had this issue.
Logged
Mics: Sennheiser MKE-2s/Omnis, Nak CM-300s, Nak CM-100s, CP-1s, CP-2s, AT-853s(Cards, Hypers, Omnis)
Pres: CA STC-9200, CA-UBB
Recorders: Tascam DR-2D, Deity PR-2, DR-70D

ISO: CP-3 Caps, AT-853 Subcard Caps

ilduclo

  • Guest
  • Trade Count: (0)
Re: Church UBB battery contact not snug
« Reply #2 on: April 21, 2015, 04:42:16 PM »
maybe sqeeze down the female sides with a pair of needle nose pliers? Both on the box and on the bat?
Logged

Offline dabbler

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 412
Re: Church UBB battery contact not snug
« Reply #3 on: April 23, 2015, 04:05:23 AM »
Quote from: ilduclo on April 21, 2015, 04:42:16 PM
maybe sqeeze down the female sides with a pair of needle nose pliers? Both on the box and on the bat?
That.  You can move/adjust them a little as they'll loosen up over time.
I've needed to do that several times on various 9V-using things, not just audio equipment :)
Logged
Pages: Pages1   Go Up
Previous topic - Next topic
 

RSS | Mobile
Page created in 0.052 seconds with 27 queries.
© 2002-2026 Taperssection.com
Powered by SMF