Topic: question about adjusting levels with a ua-5 > jb3 setup with svu-2 meter

[housermix]

ok, question for you guys

I am running  a ua-5 > jb3 and I just picked up a svu-2 to handle my levels? , but question is this... With the svu-2 monitoring the levels coming out of the jb3, where are you initially setting the levels on the jb3? all the way up? and what about the ua-5, , I guess I am just a little confused as far as where the adjustments are coming from for increasing or decreasing the levels?

hope that makes sense

thanks in advance

kevin

[bagtagsell]

When running that setup your adjustment needs to come from the mic input knobs.  On the front far left.

[hexyjones]

ok, question for you guys

I am running  a ua-5 > jb3 and I just picked up a svu-2 to handle my levels? , but question is this... With the svu-2 monitoring the levels coming out of the jb3, where are you initially setting the levels on the jb3? all the way up? and what about the ua-5, , I guess I am just a little confused as far as where the adjustments are coming from for increasing or decreasing the levels?

hope that makes sense

thanks in advance

kevin

If you are going UA5 > JB3 via an analog connection...just leave the jb3 at 0db and get the levels right on the UA5...then if you need a bit more, raise it on the JB3.

(there might be other opinons about this...some might say leave the JB3 at 0 and fix it in post prod...)

If you are using a digital signal to feed the JB3 - all the level setting is happening on the UA5...