I have a recording of live music (I know what a concept!) that came out well, but there is a lot of bass in it. I normally run my recordings through Audacity high pass filter at 80Hz 6db. In this case, there was still a lot of undesirable bass left. I should mention that I record in 24/48.
What I did next was to create a 10 minute sample from the above recording down-sampled to 16 bits and with the above high pass filter already applied. Then I used values from 90 - 160 (counting by tens) for the cut off and saved the results. So in the end I had a sample with a HPF at 90Hz 6db, another one at 100hz 6db. etc. I burn these to disk and listen in my car where I can hear how they sound (headphones are good, but for bass I really need to hear it through speakers. My car system is very high end, so it is a good test of how it sounds.
My question is, am I going about this correctly? For instance, should I be lowering the db slope (for instance from 6 to 12 or even lower than that) before I raise the frequency? If you have wrestled in the past with excessive bass and have any advice, I would appreciate it immensely. Thanks!