tbar fit mic stand?

[Fried Chicken Boy]

Well done, Todd, and nicely clarified.  The only thing is your point 4b: the K&M 23550 bar already comes with two thread adapters that screw onto the thumb screws on the bar to lock them in place.  At least the K&M bar did when I bought one.  Then again, having a few more thread adapters on hand, especially for just another couple dollars, is not a bad thing. 

[bryonsos]

This is the one I covet:

http://www.bhphotovideo.com/c/product/611468-REG/Avenger_A0035B_A0035B_Baby_Alu_Stand.html

This is the one I have:

http://www.bhphotovideo.com/c/product/546527-REG/Manfrotto_367B_367B_Basic_Light_Stand.html

Nothing wrong with the one I have, but the Avenger is way sturdier, and the leveling leg is great for outside.

[newplanet7]

Well done, Todd, and nicely clarified.  The only thing is your point 4b: the K&M 23550 bar already comes with two thread adapters that screw onto the thumb screws on the bar to lock them in place.  At least the K&M bar did when I bought one.  Then again, having a few more thread adapters on hand, especially for just another couple dollars, is not a bad thing. 

Gracias!
The weird thing about that is it lists the same bar, same part number differently on various sites.
So I just went to the actual K&M site and got the actual # which is 23550 and shows it with 3/8" mic screws.
The pic on the B&H site acttually shows the mic bar flipped over so you only see the mic holder screw knobs not the threading.
The only thing consistent about this is the inconsistency