NJB3 meters

[shaggy]

Could someone gime me the poop on the NJB3's meters?  They aren't really marked, I have too little time to test out the finer points of deciphering the levels from those meters.  Running v1.40.06p

Thanks,

ANDY

[bhtoque]

well, it is hard to be very specific, but about 1/2 way is -12, just below the top section is -3 and if it goes into the top section, you're over.

With the -3 light blinking slightly on my ua-5 I get perfect levels on the jb3.

JAson

[rowjimmytour]

Score a SVU-1 here at this link brought to you by the friendly taper community! It well save you alot of head aches later.
http://www.taperssection.com/yabbse/index.php?topic=19556.0

[pfife]

well, it is hard to be very specific, but about 1/2 way is -12, just below the top section is -3 and if it goes into the top section, you're over.

With the -3 light blinking slightly on my ua-5 I get perfect levels on the jb3.

JAson

This is exactly the same deal for me.  I actually run it a little hotter than this.

[hexyjones]

TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...

I had mine hooked up to a sony pro DAT dig out...the delay was visually obvious...the peak would occur on the Sony before it showed on the JB3

[Chris K]

rely on your A/D for metering not the jb3

[bhtoque]

TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...

I had mine hooked up to a sony pro DAT dig out...the delay was visually obvious...the peak would occur on the Sony before it showed on the JB3

Of course it's not a scientific test or anything, but with a d8 on the coax of the ua-5 and the jb3 on the optical they seemed in synch.
hard to watch both at the same time though.

+t to you for having sharper eyes than me.

JAson

[ashevillain]

TAKE NOTE : The meters on these things are very SLOW...there must be a least a few millisecond delay...

Q4T

mosdef not in sync with the sbm-1 over light