Become a Site Supporter and Never see Ads again!
Previous topic - Next topic
Pages: Pages1   Go Down

Author Topic: How to delay one channel in Soundforge  (Read 3,238 times)

0 Members and 1 Guest are viewing this topic.

Offline anr

  • Trade Count: (1)
  • Taperssection Member
  • ***
  • Posts: 365
How to delay one channel in Soundforge
« on: October 20, 2007, 01:34:17 PM »
Hi

I have a recording which has one channel lagging the other by 0.024s (24 thou).  How can I correct this using Soundforge?  (And I'm not sure it'll make a difference!).  Any advice appreciated.

anr
Logged

Offline Evil Taper

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2,773
  • Going pro...no time for taping now
Re: How to delay one channel in Soundforge
« Reply #1 on: October 20, 2007, 03:59:13 PM »
Insert that much silence before that file.  You might have to generate it as a new file and then copy paste it.
Logged
Really not very evil at all now...

Offline anr

  • Trade Count: (1)
  • Taperssection Member
  • ***
  • Posts: 365
Re: How to delay one channel in Soundforge
« Reply #2 on: October 20, 2007, 05:09:57 PM »
ET

Thanks.  Worked it out. 

Left Ch leads by .024.  Copy LHC to clipboard.  Mute LHC.  Place cursor at .024.  Edit > Paste Special > Mix > paste at cursor.
Logged

Offline gratefulphish

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1,566
  • Gone Tapin'
Re: How to delay one channel in Soundforge
« Reply #3 on: October 24, 2007, 07:31:45 PM »
+T  as I was just about to post the exact same question.  Thanks.
Logged
4 channel: Neumann TLM-170R>Segue Dogstar>SD 722   2 channel: Neumann TLM-170R>Segue Dogstar>Lunatec V3>SD 722
               Linked to Lunatec V3>MT 24/96                                     (Hi-Ho Silver Interconnects)     

Other gear: AKG C451Es, Tascam DA-P1, Sony D-8
Pages: Pages1   Go Up
Previous topic - Next topic
 

RSS | Mobile
Page created in 0.148 seconds with 27 queries.
© 2002-2026 Taperssection.com
Powered by SMF