Become a Site Supporter and Never see Ads again!
Previous topic - Next topic
Pages: Pages 1 2 All   Go Down

Author Topic: RME porducts/pre-amps  (Read 13,804 times)

0 Members and 1 Guest are viewing this topic.

Offline Hypnocracy

  • Trade Count: (46)
  • Needs to get out more...
  • *****
  • Posts: 2,012
  • Hypnocratic Missionary
    • Hypno on teh LMA
Re: RME porducts/pre-amps
« Reply #15 on: January 17, 2011, 01:11:12 PM »
Quote from: fotoralf.be on January 13, 2011, 06:58:45 PM
Now, what would be the problem with its  TRS outputs? What am I missing? ;-)

Ralf


I'm guessing most here have XLR interconnects it would require new interconnects and (on my recorder) TRS is not locking...
Logged
_____________
hypno on teh Archive

This must be heaven -- 'cause here's where the rainbow ends
If this ain't the real thing, then it's close enough to pretend

Offline illconditioned

  • Trade Count: (9)
  • Needs to get out more...
  • *****
  • Posts: 3,006
Re: RME porducts/pre-amps
« Reply #16 on: January 17, 2011, 02:34:53 PM »
Quote from: RichT on January 17, 2011, 06:47:19 AM
Also RME tend to run two different families of pre-amps
Fireface 800, Octamic, Quadmic are all similar.

Most of the newer interfaces (Micstacy, Fireface 400/UC, Fireface UFX) use the TI PGA2500 which is digitally controlled and very clean. It's also in a few other products around including the Apogee Duet and MOTU Traveler Mk3
Nice to see this chip getting into products.  Much better than the typical NJM opamps we see in most gear.

  Richard
Logged
Pages: Pages 1 2 All   Go Up
Previous topic - Next topic
 

RSS | Mobile
Page created in 0.051 seconds with 24 queries.
© 2002-2026 Taperssection.com
Powered by SMF