Become a Site Supporter and Never see Ads again!

Author Topic: Tascam DR2d - part 2  (Read 97288 times)

0 Members and 1 Guest are viewing this topic.

Offline hoserama

  • (1)
  • Taperssection Member
  • ***
  • Posts: 334
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #90 on: October 06, 2012, 01:32:09 PM »
As far as I know, you can only monitor the mic-in while recording. Heck if the original firmware did allow you to switch the headphone monitoring, I'd go back to it, batteries be damned. But yes, the button does toggle between the levels.

I just wish it had a little onboard mixer like the H4n, would make things so much nicer.

Does anybody have a 2D with the original firmware and comment on the headphone monitoring on the dual recording?
Audio: Countryman B3 + SBD feeds
Wireless Receivers: Lots of those
Antennas: Lots of those
Cables: Lots of those
Recorders: Cymatic Utrack24, Cymatic LR16, RME Multiface, Zoom F8, (3) Tascam 680, (2) Tascam 2D, Zoom H6, Zoom H4n, and a graveyard of irivers/nomads/minidiscs.

Offline darby

  • (97)
  • Taperssection All-Star
  • ****
  • Posts: 1290
  • Support artists and venues that allow recording
Re: Tascam DR2d - part 2
« Reply #91 on: October 06, 2012, 06:36:10 PM »
As far as I know, you can only monitor the mic-in while recording. Heck if the original firmware did allow you to switch the headphone monitoring, I'd go back to it, batteries be damned. But yes, the button does toggle between the levels.

I just wish it had a little onboard mixer like the H4n, would make things so much nicer.

Does anybody have a 2D with the original firmware and comment on the headphone monitoring on the dual recording?

you obviously didn't use a DR-2d with the original firmware  ::) I got about 35 minutes on a set of NiMHs

Offline hoserama

  • (1)
  • Taperssection Member
  • ***
  • Posts: 334
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #92 on: October 06, 2012, 07:16:26 PM »
Ha pretty much--I updated the firmware before I basically started fiddling with it.
Audio: Countryman B3 + SBD feeds
Wireless Receivers: Lots of those
Antennas: Lots of those
Cables: Lots of those
Recorders: Cymatic Utrack24, Cymatic LR16, RME Multiface, Zoom F8, (3) Tascam 680, (2) Tascam 2D, Zoom H6, Zoom H4n, and a graveyard of irivers/nomads/minidiscs.

Offline aleal5687

  • (29)
  • Taperssection Member
  • ***
  • Posts: 340
Re: Tascam DR2d - part 2
« Reply #93 on: October 06, 2012, 09:05:17 PM »
I have a loud show coming up and want to keep it simple.

CA14 Cards (modded by Chris to run of PIP)-> DR2d (mic in PIP on).

Should I run a 20db attenuator? ( from coresound)

Will it reduce the amount of PIP the mics get?

This will be my first outing with this set up.

The music will be very bass heavy.


Mics:CA11,CA14,AKG ck91(Homebrew active)
Pre/power: Ca Ugly, Oade mod sbm1,sp battery box,MT mic power
Recorder:R9HR,MT 24/96,Iriver ihp110(16gb cfmod)

Offline Gil

  • (5)
  • Needs to get out more...
  • *****
  • Posts: 6625
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #94 on: October 08, 2012, 12:28:19 PM »
I will be joining the team in 4-6 business days.
"Let's go do some crimes."

"To his mind, an opportunity to insult a successful ape came from the hand of Providence."

Teac ME-80(cards & omnis), AT943(hypers)>Tascam DR-2d

Offline OOK

  • (17)
  • Needs to get out more...
  • *****
  • Posts: 2727
  • Gender: Male
  • formerly OtherOneK
Re: Tascam DR2d - part 2
« Reply #95 on: October 08, 2012, 01:07:38 PM »
I will be joining the team in 4-6 business days.

way to go!
DPA/HEB 4060's > R09HR
MBHO648/KA100Lk/KA200/KA300/KA500 > SD702

stevetoney

  • Guest
  • (0)
Re: Tascam DR2d - part 2
« Reply #96 on: October 08, 2012, 03:11:57 PM »
I will be joining the team in 4-6 business days.

Nice.  Did you get a good deal?

Offline Gil

  • (5)
  • Needs to get out more...
  • *****
  • Posts: 6625
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #97 on: October 08, 2012, 03:20:57 PM »
I will be joining the team in 4-6 business days.

Nice.  Did you get a good deal?

Good enough, I suppose. $134.99.
« Last Edit: October 09, 2012, 08:13:06 AM by Porno Gil »
"Let's go do some crimes."

"To his mind, an opportunity to insult a successful ape came from the hand of Providence."

Teac ME-80(cards & omnis), AT943(hypers)>Tascam DR-2d

colinw

  • Guest
  • (0)
Re: Tascam DR2d - part 2
« Reply #98 on: October 31, 2012, 10:10:35 AM »
Hi all, just joined the team with my recent purchase of a dr2d!

I have been running a simple 2 channel setup for a while now using a TASCAM dr07mkii, Church mics, and a regular battery box.

I also recently bought a new Naiant Tinybox, and will soon be buying some larger open taping mics to complete my rig.

For the dr2d, from reading the multiple pages and threads I seem to need to do the following:
1. update firmware
2. set mic in to about 67, and line in to 95. Are these the optimal settings for recorder gain?
3. adjust gain with the Tinybox not the dr2d? I am used to using my dr07mkii to adjust gain, so that will be a little different, as the Tinybox goes in increments, and can't be "finetuned" like it would be with the recorder.

When using the Church CA14s or any other external mic, should I be using mic in or line in? Does it matter for a single set of mics?

I am looking forward to recording with two sets of mics, and also doing 4 channel with SBD and ambient mic input.

Colin

Offline ohm-ish

  • (0)
  • Taperssection Newbie
  • *
  • Posts: 6
Re: Tascam DR2d - part 2
« Reply #99 on: November 01, 2012, 11:06:52 AM »
Does anyone know what "power" (on/off) in the "input setting" menu means?

Offline dallman

  • Site Supporter
  • (30)
  • Taperssection All-Star
  • *
  • Posts: 1714
  • Gender: Male
    • Clifford Morse
Re: Tascam DR2d - part 2
« Reply #100 on: November 01, 2012, 11:17:03 AM »
Does anyone know what "power" (on/off) in the "input setting" menu means?
That addresses "plug in power" for your "mic in" jack.
Support Live Music: Tape A Show Today!
Deck>possibly something here> Mics

Offline Gil

  • (5)
  • Needs to get out more...
  • *****
  • Posts: 6625
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #101 on: November 01, 2012, 11:22:07 AM »
Looks like I'll be attempting my first four-channel recording tonight.
« Last Edit: November 01, 2012, 04:29:00 PM by Porno Gil »
"Let's go do some crimes."

"To his mind, an opportunity to insult a successful ape came from the hand of Providence."

Teac ME-80(cards & omnis), AT943(hypers)>Tascam DR-2d

Offline OOK

  • (17)
  • Needs to get out more...
  • *****
  • Posts: 2727
  • Gender: Male
  • formerly OtherOneK
Re: Tascam DR2d - part 2
« Reply #102 on: November 02, 2012, 05:40:07 PM »
Looks like I'll be attempting my first four-channel recording tonight.

Well?
DPA/HEB 4060's > R09HR
MBHO648/KA100Lk/KA200/KA300/KA500 > SD702

Offline F.O.Bean

  • Team Schoeps Tapir that
  • (126)
  • Needs to get out more...
  • *****
  • Posts: 40676
  • Gender: Male
  • Taperus Maximus
    • MediaFire Recordings
Re: Tascam DR2d - part 2
« Reply #103 on: November 02, 2012, 11:04:02 PM »
Looks like I'll be attempting my first four-channel recording tonight.

Well?

SBD/Teac matrix ???
Schoeps MK 4V & MK 41V ->
Schoeps 250/0 KCY's (x2) ->
Naiant +60v/Low Noise PFA's (x2) ->
DarkTrain Right Angle Stubby XLR's (x3) ->
Sound Devices MixPre-6 & MixPre-3 ->
SanDisk 128gb Extreme Pro & 64gb Ultra Plus SDXC-I

http://www.archive.org/bookmarks/diskobean
http://www.archive.org/bookmarks/Bean420
http://bt.etree.org/mytorrents.php
http://www.mediafire.com/folder/j9eu80jpuaubz/Recordings

Offline Gil

  • (5)
  • Needs to get out more...
  • *****
  • Posts: 6625
  • Gender: Male
Re: Tascam DR2d - part 2
« Reply #104 on: November 03, 2012, 11:24:32 AM »
Looks like I'll be attempting my first four-channel recording tonight.

Well?

Just sat down with it now. It was the Hackensay Boys here in tahn on Thurs.

Looks like I'll be attempting my first four-channel recording tonight.

Well?

SBD/Teac matrix ???

Yup.
"Let's go do some crimes."

"To his mind, an opportunity to insult a successful ape came from the hand of Providence."

Teac ME-80(cards & omnis), AT943(hypers)>Tascam DR-2d

 

RSS | Mobile
Page created in 0.06 seconds with 43 queries.
© 2002-2020 Taperssection.com
Powered by SMF