Become a Site Supporter and Never see Ads again!

Author Topic: Clipping  (Read 1940 times)

0 Members and 1 Guest are viewing this topic.

Offline in2blues

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 141
« on: February 05, 2017, 01:01:09 PM »
I mostly use  Church Ca-11>Church battery box>Sony PCM-M10. When I set levels I usually turn up till just clips red lights, then back off a notch.  Looking at recordings it seems like I should be recording at higher levels but I'm afraid of clipping in recording. This "clipping" happened the first time I used deck but didn't have battery box at that time. Should I be setting my levels higher ? and does battery box make difference when setting levels?

Offline ilduclo

  • Trade Count: (4)
  • Needs to get out more...
  • *****
  • Posts: 5069
Re: Clipping
« Reply #1 on: February 05, 2017, 01:19:26 PM »
battery box shouldn't make any difference with levels, but be sure to use it and make sure the battery is fresh (replace every 3 months or so, and don't leave mics plugged into it when you are not recording or getting ready to record, that is don't leave it on the shelf for days with the mics plugged into the battery box)

you absolutely need the battery box when recording!

you can record at a lower level than red, I try to keep the db meters at -12 or less, but record at 24 bit then you can amplify when you are processing your recording.

Offline nulldogmas

  • Trade Count: (3)
  • Taperssection Member
  • ***
  • Posts: 849
Re: Clipping
« Reply #2 on: February 05, 2017, 07:06:55 PM »
The goal should be to never clip red. If you record in 24-bit, peaking around -12dB (i.e., just occasionally triggering the yellow lights) is plenty of signal.

That said, if you turn the M10's limiter on, it will handle the occasional accidental red clip.

Offline Cheesecadet

  • Trade Count: (21)
  • Needs to get out more...
  • *****
  • Posts: 2756
  • Gender: Male
Re: Clipping
« Reply #3 on: February 06, 2017, 11:07:33 AM »
I personally like to run my levels at about -6dB with peaks around -3dB. I use an m10 with limited just in case. I just like the way my recordings sound at those levels. Seems like bass is punchier if that makes send also keeps the noise floor lower when editing in post in my experience
AKG481's | DPA4061's | AT933's (w/ AT853 SC/C/O ELE's) | ECM19B's | SD MixPre-3 | PCM-M10 x 2 | Shure FP24 | Tinybox v1.5 | PIPsqueak | Darktrain/GAKables

02/21 Love Canon
02/28 GSBG or DFB
03/05 Turkuaz
03/06 Spafford
04/05 String Cheese Incident
04/14 The Wailers
04/26 Bluegrass Generals
05/16 Miles 4tet/ Frisell


RSS | Mobile
Page created in 0.138 seconds with 32 queries.
© 2002-2019
Powered by SMF