Become a Site Supporter and Never see Ads again!

Author Topic: bridgeing speaker outs on receiver  (Read 946 times)

0 Members and 1 Guest are viewing this topic.

Offline cwfen

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 841
  • Gender: Male
bridgeing speaker outs on receiver
« on: October 15, 2004, 01:39:17 PM »
Hey- is it possible to bridge the out puts of a receiver to get more power to speaker? Lets say you had an old receiver with 4 channels at 25watts each, but your A+B switch wasn't working... could you bridge the A outputs and B outputs (Right to Right, Left to Left and then each to the proper speaker) thus getting 50watts per two channels?

 

RSS | Mobile
Page created in 0.096 seconds with 29 queries.
© 2002-2019 Taperssection.com
Powered by SMF