Become a Site Supporter and Never see Ads again!

Author Topic: UA5 (line out, bypass the ADC mod) ?  (Read 1217 times)

0 Members and 1 Guest are viewing this topic.

Offline Javier Cinakowski

  • !! Downhill From Here !!
  • Trade Count: (11)
  • Needs to get out more...
  • *****
  • Posts: 4318
  • Gender: Male
UA5 (line out, bypass the ADC mod) ?
« on: April 26, 2007, 09:23:14 AM »
Anyone ever look at modding the line-out of the UA5 so that it bypasses the ADC/DAC.

This would be usefull if you wanted to run the UA5 into a better ADC, or for patches, etc....

I am no electronic guru, but it seems logical that you could run wire from the end of the gain stage before it hits the ADC and run it directly over to the line-out.  The only problem with this is you would not get the line-in information sent to the line-out, only the mic-in.  To solve that you could make a switch to keep the line-out as is, or have direct analog passthrough.

Thoughts?
Audio-Technica AT8022-> Tascam DR-100mkIII

Offline Krispy D

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4878
  • Gender: Male
    • my recordings on LMA
Re: UA5 (line out, bypass the ADC mod) ?
« Reply #1 on: April 26, 2007, 10:04:48 AM »
for some reason I remember that this is not that easy.  It's been a while since I looked into this but I imagine someone would have done it by now.
Peluso CEMC6, ck4/ck21
Oktava MC012
Sony ECM260f
AT 811

canare star quads
DIY mil spec silvers

DIY (W-ish) mod UA5>JB3
Oade ACM PMD 660
R4


You cannot strengthen the weak by weakening the strong. You cannot help the wage-earner by pulling down the wage-payer. You cannot help the poor by destroying the rich. You cannot help men permanently by doing for them what they could and should do for themselves.
~Rev. William J. H. Boetcker (not Lincoln)

 

RSS | Mobile
Page created in 0.04 seconds with 44 queries.
© 2002-2020 Taperssection.com
Powered by SMF