Become a Site Supporter and Never see Ads again!
Previous topic - Next topic
Pages: Pages 1 2 All   Go Down

Author Topic: Spectrum analysis to calibrate tape azimuth?  (Read 16,935 times)

0 Members and 1 Guest are viewing this topic.

Offline it-goes-to-eleven

  • Trade Count: (58)
  • Needs to get out more...
  • *****
  • Posts: 6,690
Re: Spectrum analysis to calibrate tape azimuth?
« Reply #15 on: February 11, 2008, 11:51:26 AM »
Sorry.. I should have said wavelab and not wave.
Logged

Offline sunjan

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2,006
  • Taping since 1988, 28 years of fine recordings...
    • Just a handful of stuff I put on etree
Re: Spectrum analysis to calibrate tape azimuth?
« Reply #16 on: February 12, 2008, 06:05:43 AM »
Quote from: Freelunch on February 11, 2008, 11:51:26 AM
Sorry.. I should have said wavelab and not wave.

T+ thanks freelunch! Do you know if real time monitoring is supported in older versions, or only the latest?!

/J
Logged
Mics: A-51s LE, CK 930, Line Audo CM3, AT853Rx (hc,c,sc),  ECM 121, ECM 909A
Pres: Tinybox, CA-9100, UA5 wmod
Recorders: M10, H116 (CF mod), H340, NJB3
Gearbag: High Sierra Corkscrew
MD transfers: MZ-RH1. Tape transfers: Nak DR-1
Photo rig: Nikon D70, 18-70mm/3.5-4.5, SB-800
Pages: Pages 1 2 All   Go Up
Previous topic - Next topic
 

RSS | Mobile
Page created in 0.124 seconds with 24 queries.
© 2002-2026 Taperssection.com
Powered by SMF