Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: mterry on June 03, 2009, 10:12:04 AM
-
In case anyone has been looking for a GOOD windscreen to fit these puppies, look no further. Its the Audix WS1281, only available from Audix. I looked all over google for any dealers, but going straight to Audix is the best bet.
(http://i42.tinypic.com/2u8ccaa.jpg)
-
Can you measure the inside diameter and depth of the bore on these screens? Considering them for the DPA 4098H if they will fit. Thanks.
-
Can you measure the inside diameter and depth of the bore on these screens? Considering them for the DPA 4098H if they will fit. Thanks.
I actually bought Mark's M1280s and am the current owner of those windscreens. The diameter is about 1/4" (with some room for expansion due to the stretchable nature of the foam) and the depth is about 1 3/4". Hope that helps!
-
Excellent, thanks!
Now I can double check.. might be a bit loose and short on the DPAs
-
Are the stock screens ok? I still have them...
Those look nice!
-
I've actually got 3 sets of windscreens that fit the Audix M series. The ones pictured above and a smaller set that are about 1/2 the exterior size of the ones I measured for Gutbucket came with the M1280s I got from mterry. I also bought a set of M1290s from the YS that came with the original wood boxes and included a tiny set of windscreens that are much thinner and about 1/2 the size of the smaller set from the M1280s. I don't think I've ever used the smallest set, but the 2 larger sets have worked quite well for me both indoors and outdoors.