Become a Site Supporter and Never see Ads again!

Author Topic: CA-11 > M-10  (Read 2617 times)

0 Members and 1 Guest are viewing this topic.

Offline Mikel

  • Trade Count: (1)
  • Taperssection Newbie
  • *
  • Posts: 36
  • Gender: Male
CA-11 > M-10
« on: January 30, 2011, 03:04:09 PM »
Does anyone else run this setup?? CA-11's w/9vBB > Sony M-10. I ran this last nite and the low end isn't there. I know the low cut filter was on but would that cause a major drop in the low end? FWIW I have ran the CA-11's to an Oade mod UA-5 and have had great results.
Nakamichi CM-300>Apogee MiniMe>Microtrack II
CA-11 >>Littlebox>> PCM-M10

Offline su6oxone

  • Trade Count: (38)
  • Needs to get out more...
  • *****
  • Posts: 2761
Re: CA-11 > M-10
« Reply #1 on: January 30, 2011, 03:44:23 PM »
I know the low cut filter was on but would that cause a major drop in the low end?

probably

Offline fmaderjr

  • Trade Count: (16)
  • Taperssection All-Star
  • ****
  • Posts: 1966
Re: CA-11 > M-10
« Reply #2 on: January 30, 2011, 04:01:09 PM »
I know the low cut filter was on but would that cause a major drop in the low end?

probably

That must be it because there is no other reason that a recording with a CA-11 should be severely lacking in bass. The M10's is a fine recorder.

There are many warnings on this site about using bass roll offs except in the most extreme circumstances of too much bass at the venue.
AT853's (all caps)/CM-300 Franken Naks (CP-1,2,3)/JBMod Nak 700's (CP-701,702) > Tascam DR-680
Or Sonic Studios DSM-6 > M10

 

RSS | Mobile
Page created in 0.046 seconds with 32 queries.
© 2002-2024 Taperssection.com
Powered by SMF