If I still have the mics in November. I'll run both for Mule. Need to figure out how to set up the Church Audio cards to the Busman mic mounts.
Mako
1. Undo the elastic on the bottom and one of the upper "hooks".
2. Slide the CA14 through the clip like you usually would... except slide it all the way through. The cable should now be sitting on the clip.
3. Bring the cable through the area's that you removed the elastic from the hooks, so now the mics are underneath the clip.
4. Re-hook the elastic's back in place.
5. Do the same for the other mount.
6. Pull the cables taught and velcro them to your stand. This will keep em in place.
7. Make sure that if you run both pairs of mics, that you have em correctly placed. Left with left. Right with right.
OR...
You can probably put the end of the mic/cable into the "lock" that is on the mounts... the "switch" that locks your cables down.
I have done both, and both ways seem to work well... it just might take a little bit of time to figure it out. I don't have the CA14's anymore, so I can't take a pic... I could try and show an example if needed.
edit: come to think of it, I have a sample of BSC1-K1(cards) vs. CA14cards that I'll post.