Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Microtrack II DMA recommended setting?  (Read 3779 times)

0 Members and 1 Guest are viewing this topic.

Offline manleyf

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 109
  • Gender: Male
  • http://SoulCoustic.com
    • Separate Reality Productions
Microtrack II DMA recommended setting?
« on: October 02, 2009, 02:16:39 PM »
I know I've seen this in a post somewhere, and I've been searching for over 10 minutes, but it seems maybe "dma" is too short for the search engine?

Anyway, is it recommended to run with DMA on or off?

I'm using an older Kingston 4gb 45x card, and an older Transcend 8gb 120x card.

Both have these have worked flawlessly with my old MT, and I'm just hoping for the most stable out of the gate with out having problems...

TIA!
Manley
Logged
Earthworks SR30/SRO > V3 > MT/JB3
Church Audio Pro-Cards/Mini-Omnis > ChruchAudio 9100 PreAmp > MT/JB3
http://RecordMeLive.com
http://SoulCoustic.com

Offline taperwheeler

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 496
  • Gender: Male
Re: Microtrack II DMA recommended setting?
« Reply #1 on: October 02, 2009, 03:47:06 PM »
I have never used dma and coincidentally haven't had any probs.  My .02
Logged
Mics: SP-CMC-8 AT933 Body 4.7K mod AT853 (c, sc) U853 (h) Microline Shotguns
Pres: CA 9100, SP-Preamp
Recorders: MT2 , Tascam DR-07, PCM-M10, PCM A10

Offline popskull

  • Trade Count: (3)
  • Taperssection Member
  • ***
  • Posts: 610
  • Gender: Male
  • Analog....the ultimate sampling frequency
Re: Microtrack II DMA recommended setting?
« Reply #2 on: November 19, 2009, 01:19:30 PM »
My MTII froze up when doing 24/96 coax from the Apogee Mini Me when the DMA was in the On position.

I turned it off and have had no problems since
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.043 seconds with 26 queries.
© 2002-2025 Taperssection.com
Powered by SMF