Here we go:
I was at Lowes (again) and was looking at plumbing parts for stuff...
I found some CPVC 1/2" pipe 45° angles that looked like just the right size for the Milab VM 44 links to be "mounts" for a DIN Bar (or you could do a NOS bar too).
the 1/2" pipe was too small in diameter, and the 3/4" looked a bit bigger than the 1/2" schedule 40 PVC
here is the 45° angle part:
and here is my DIY thread: DIN active Bar (90° @ 20cm)
(I made this for my own use, I will NOT be producing them for others) However if someone would like to take the idea and better it or mass produce it that that's fine, hopefully Milab may make their won series of pattern bars for ORTF, DIN, and NOS, unitl then, here is my fun!
finished:
Start:
Raw CPVC Pipe:
Raw cut parts:
close up of 45° angle Pre Cut parts:
center 1/2" pipe - pre-cut with 3/4" shrink tube package:
center with Shrink tubing in place:
center with shrunk tube:
parts all together now (unglued):
Glued with CPVC cement:
Glued and sanded:
texture spray paint:
painted bar:
bar with VM44-links
links with "paperclip" clips
bar n links at 20cm:
all set with windscreens:
bar n mics in shock mount:
Ready to Roll:
questions or comments welcome
enjoy
--Ian
Topic: DIY: DIN bar for Milab VM44-links (Read 6262 times)