Corey, I'll try and break this down for you simply because it's getting confusing. 1) Look at
THIS PIC (The 3rd one in) of the threaded tip
of your stand. It's 1/4" wide.
2) No t-bar will fit direct on that stand because all t-bars center mounting holes
that I know of are either 3/8" or 5/8" round.
3) The bar you linked to is a 3/8" center hole. It's the same one Bryonsos and Darby have.
4) If you get that stand and that bar here is what you WILL need to get also. a) Manfrotto Rapid Adapter (#014-38) which has the 3/8" threaded tip. This will go right over the whole top of your stand.
Then the t-bar will screw directly onto that Rapid adapter. Easy as pie.
b) Get TWO of these
THREAD ADAPTERS to fit your mic holders/clips/shockmounts on the two 3/8" threaded screws that are on the actual bar. These convert the two screws on the bar
to the exact thread size that will screw into the bottoms of your mic holders/clips/shockmounts which are 5/8"
5) Darby's picture above shows the Rapid Adapter's 3/8" threaded tip going straight into his t-bar with a 3/8" ctr hole.
This will be exactly what you will be doing.3/4 of the sites have that t-bar listed wrong. Get it from full compass because they have it listed right.
http://www.fullcompass.com/product/338507.html-todd