Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: mic placement  (Read 2651 times)

0 Members and 1 Guest are viewing this topic.

Offline JimmieC

  • Trade Count: (7)
  • Taperssection Member
  • ***
  • Posts: 520
  • Gender: Male
mic placement
« on: December 14, 2012, 10:07:38 PM »
If you have to set up microphone stand on the right speaker / side of stage,  would you still sit up ortf or adjust to speakers?  Still back may be 25 or 30 feet in a small room.
Logged
OH Grown
Mic:AKG C460B(CK61)/HM1000(CK32/CK47), Naiant Couplings/PFA, ADK-TL; Preamp:Lunatec V2, Naiant Littlebox v1.5; Rec:Tascam DA-P1/DR-100mkii/DR-680; Cable:GAKcables; Bar:Shure A27M, Robb Bar 23-cm, it-goes-to-eleven DINa Active Bar, GAK 3' Bar; Mount:Shure A53M, Audix MC-MICRO; Clamp:AKG K&M 237, Photek Grip Clamp w/Manfrotto 042; Stand: Manfrotto Alu Master 3 Riser 12' AC Stand/122B, Lowel Full Pole; Battery:18000mah Universal Lithium Battery; Playback:laptop>Schiit Modi>Yamaha HTR5890>Klipsch Synergy F2. My recordings on LMA

Offline JimmieC

  • Trade Count: (7)
  • Taperssection Member
  • ***
  • Posts: 520
  • Gender: Male
Re: mic placement
« Reply #1 on: December 14, 2012, 11:03:49 PM »
Light crowd and rearranged the tables so set up center.
Logged
OH Grown
Mic:AKG C460B(CK61)/HM1000(CK32/CK47), Naiant Couplings/PFA, ADK-TL; Preamp:Lunatec V2, Naiant Littlebox v1.5; Rec:Tascam DA-P1/DR-100mkii/DR-680; Cable:GAKcables; Bar:Shure A27M, Robb Bar 23-cm, it-goes-to-eleven DINa Active Bar, GAK 3' Bar; Mount:Shure A53M, Audix MC-MICRO; Clamp:AKG K&M 237, Photek Grip Clamp w/Manfrotto 042; Stand: Manfrotto Alu Master 3 Riser 12' AC Stand/122B, Lowel Full Pole; Battery:18000mah Universal Lithium Battery; Playback:laptop>Schiit Modi>Yamaha HTR5890>Klipsch Synergy F2. My recordings on LMA

Offline acidjack

  • Site Supporter
  • Trade Count: (37)
  • Needs to get out more...
  • *
  • Posts: 5845
  • Gender: Male
Re: mic placement
« Reply #2 on: December 15, 2012, 02:58:11 PM »
Would need to see the room but I would not roll ORTF. If anything I'd either go A-B and point at the right stack or make a minimal angle with the right mic slightly outside the right stack and the left one facing as much toward the left stack as you can comfortably. 
Logged
Mics: Schoeps MK4V, MK41V, MK5, MK22> CMC6, KCY 250/5, KC5, NBob; MBHO MBP603/KA200N, AT 3031, DPA 4061 w/ d:vice, Naiant X-X, AT 853c, shotgun, Nak300
Pres/Power: Aerco MP2, tinybox v2  [KCY], CA-UBB
Decks: Sound Devices MixPre 6, Zoom F8, M10, D50

My recordings on nyctaper.com: http://www.nyctaper.com/?tag=acidjack | LMA: http://www.archive.org/bookmarks/acidjack | twitter: http://www.twitter.com/acidjacknyc | Soundcloud: https://soundcloud.com/acidjacknyc

Offline JimmieC

  • Trade Count: (7)
  • Taperssection Member
  • ***
  • Posts: 520
  • Gender: Male
Re: mic placement
« Reply #3 on: December 15, 2012, 03:20:19 PM »
Yeah, that was what I was going to do but was able to move center when not to many people showed up and not worried about the dancers.  It had been awhile since taping so thought I would ask here what you guys do.  It turned out pretty good.  Thanks.
« Last Edit: December 15, 2012, 03:59:42 PM by JimmieC »
Logged
OH Grown
Mic:AKG C460B(CK61)/HM1000(CK32/CK47), Naiant Couplings/PFA, ADK-TL; Preamp:Lunatec V2, Naiant Littlebox v1.5; Rec:Tascam DA-P1/DR-100mkii/DR-680; Cable:GAKcables; Bar:Shure A27M, Robb Bar 23-cm, it-goes-to-eleven DINa Active Bar, GAK 3' Bar; Mount:Shure A53M, Audix MC-MICRO; Clamp:AKG K&M 237, Photek Grip Clamp w/Manfrotto 042; Stand: Manfrotto Alu Master 3 Riser 12' AC Stand/122B, Lowel Full Pole; Battery:18000mah Universal Lithium Battery; Playback:laptop>Schiit Modi>Yamaha HTR5890>Klipsch Synergy F2. My recordings on LMA
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.035 seconds with 27 queries.
© 2002-2025 Taperssection.com
Powered by SMF