New SONY PCM-A10

[jerryfreak]

you could 3d print it i guess

its already REALLY small

wait till you get one in your hands

I would honestly rather get rid of the external mics on this thing. I would never use them. Unless there was a way to take some AT853 (4.7k mod) and put them in that housing.

You said you could make a new backing for it to make it slimmer. How would you go about this. I am curious. You have peaked my interest a lot!

I did pull the trigger and order one of these. Looking forward to using it in a couple weeks time for my next show!

[Sebastian]

sitting beside the unit. pop off the rectangular rubber plug at the top

Any recommendations on how to do that without damaging it? Mine seems to be super glued.

[jerryfreak]

sitting beside the unit. pop off the rectangular rubber plug at the top

Any recommendations on how to do that without damaging it? Mine seems to be super glued.

id use a small flathead and try to get under the short edge and pry up. The cap is kinda rubbery so you should be able to push it towards the center and get underneath it. I used a box cutter and it cut the soft plug

[ycoop]

While you're doing all this surgery care to take a multimeter reading of the PIP voltage?

[jerryfreak]

While you're doing all this surgery care to take a multimeter reading of the PIP voltage?

you dont need to open it up to measure PIP, see older posts in this thread

[ycoop]

While you're doing all this surgery care to take a multimeter reading of the PIP voltage?

you dont need to open it up to measure PIP, see older posts in this thread

I'm aware, I meant in regards to already having the multimeter at the ready. I've read the thread as it was happening, though I don't recall anyone taking a measurement. Care to refresh my memory so that I don't need to re-read 20 pages of posts?

[jerryfreak]

2.75V unloaded, 2.2-2.4ish V loaded with DPAs

[Brian Emerick]

what is "PIP" again?

[jerryfreak]

"plug in power" usually found on 1/8" trs mic input jacks

[Brian Emerick]

thanks, gotcha.

[ycoop]

2.75V unloaded, 2.2-2.4ish V loaded with DPAs

Thanks.

[edtyre]

Why the a-10 is a keeper

https://soundcloud.com/edtyre/the-who-2019-05-26-cittzens-bank-park-were-not-gonna-take-it-see-me-feel-me

or this

https://soundcloud.com/edtyre/the-black-lillies-2019-05-09-sellersville-theater-snakes-and-telephones

[Popmarter]

follow

[thebeaker]

Hi, i just bought it and am confused.
I use Church audio ca and batterybox.
When i select external Settings there is "mic in" and "audio in" to select. What shall i choose here?
And is the locut just a Base roll off or a hard cut of Bass?

[jerryfreak]

does your bat box have gain? line in prob safest bet