Become a Site Supporter and Never see Ads again!

Author Topic: ISO: Cable repair  (Read 1118 times)

0 Members and 1 Guest are viewing this topic.

Offline Hand in Hand

  • (0)
  • Taperssection Newbie
  • *
  • Posts: 3
ISO: Cable repair
« on: June 08, 2020, 11:34:30 PM »
I have some cables which need their ends/connector swapped. Mostly XLR and TA5 (mini-XLR). I supply the connectors and cables.
May I please get a newbie "without-an-income" rate?

Offline heathen

  • (23)
  • Needs to get out more...
  • *****
  • Posts: 3202
Re: ISO: Cable repair
« Reply #1 on: June 09, 2020, 12:29:16 AM »
Have you thought about trying it yourself?  What you're asking for is fairly simple (if I can do it anyone can).  You would need to get some supplies though (soldering station, solder, wire cutters, and ideally some sort of third hand).

If I were a bit more confident in my abilities I'd offer to do it for you, but I'm only confident enough to do stuff for my own use.
Mics: AT4050ST | AT4031 | AT853 (C/SC) | Line Audio CM3 | Sennheiser e614 | Sennheiser MKE2 | DPA 4061 | CA-14 omni Pres: CA9200 | DPA d:vice Decks: Zoom F8 | Roland R-05

Offline jerryfreak

  • (31)
  • Needs to get out more...
  • *****
  • Posts: 5479
  • The plural of anecdote is not data
Re: ISO: Cable repair
« Reply #2 on: June 10, 2020, 11:21:46 AM »
People whose posts I wont see:
 capnhook, daspyknows, Melanie, morst, Rob D., Scooter123, Sloan Simpson, Walstib62, Dr. Bickart

 

RSS | Mobile
Page created in 0.029 seconds with 31 queries.
© 2002-2020 Taperssection.com
Powered by SMF