Become a Site Supporter and Never see Ads again!

Author Topic: Record Levels With Schoeps/Naiant IPA Combo  (Read 402 times)

0 Members and 1 Guest are viewing this topic.

Offline Sevoflurane

  • (2)
  • Taperssection Member
  • ***
  • Posts: 361
  • Gender: Male
Record Levels With Schoeps/Naiant IPA Combo
« on: November 14, 2020, 09:23:46 AM »
Hey All,

Just some random question about my rig combo. I run the Schoeps with actives and a Naiant IPA. Obviously, I have not recorded anything for most of the year. But I have always had problems with recording levels. I use an M10 with the low sensitivity and then I have an IPA with a 0db gain. When I record most of the time if I record from the board I have to get the M10 level all the way up to 10 and levels don't peak at all. Maybe around -6db. If I am close to the stacks, even then, it hardly peaks and still very high on the M10 level. Especially during shows where there will be quieter segments the levels are drastic and in post trying to fix it there is so much noise floor heard.

I hope this makes sense? I guess what my question is, should I get another IPA that has some gain on it? What could my other options be? I just want more control of recording levels because I literally can just put my M10 to recording level 10 and still wish that I could get some more gain on my recordings while doing it.
http://www.ninlive.com
Mics: Schoeps MK4s, AT853 (4.7k mod)
Pre: Naiant IPA v1.0
Recorders: M10, A10, TCD-D8
Transfers: Nakamichi CR-3A, Tascam DA-20

Online aaronji

  • Site Supporter
  • (8)
  • Needs to get out more...
  • *
  • Posts: 3079
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #1 on: November 14, 2020, 10:08:48 AM »
Is that using the line input or the mic input?
People whose posts I won't see: jerryfreak. The probationary period didn't last long...

Offline Sevoflurane

  • (2)
  • Taperssection Member
  • ***
  • Posts: 361
  • Gender: Male
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #2 on: November 14, 2020, 10:42:02 AM »
Is that using the line input or the mic input?

Whoops. Should specify, line. I didn't think I could use the mic in port for this?
http://www.ninlive.com
Mics: Schoeps MK4s, AT853 (4.7k mod)
Pre: Naiant IPA v1.0
Recorders: M10, A10, TCD-D8
Transfers: Nakamichi CR-3A, Tascam DA-20

Offline jerryfreak

  • (31)
  • Needs to get out more...
  • *****
  • Posts: 5455
  • The plural of anecdote is not data
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #3 on: November 14, 2020, 03:07:49 PM »
with 0dB gain you kinda need to use mic in

perhaps jon could mod your 0dB to +18dB fixed or something

his preamp circuit should be better than whatever the M10 uses
People whose posts I wont see:
 capnhook, daspyknows, Melanie, morst, Rob D., Scooter123, Sloan Simpson, Walstib62, Dr. Bickart

Offline Sevoflurane

  • (2)
  • Taperssection Member
  • ***
  • Posts: 361
  • Gender: Male
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #4 on: November 14, 2020, 03:36:35 PM »
with 0dB gain you kinda need to use mic in

perhaps jon could mod your 0dB to +18dB fixed or something

his preamp circuit should be better than whatever the M10 uses

Honestly didn't think I could use mic in. Would be nice to have more room to work with and not have such problematic noise floor interference when there is quieter segments of a show.

Going to order the 2.0 IPA anyways. Will get some gain switches for that!
http://www.ninlive.com
Mics: Schoeps MK4s, AT853 (4.7k mod)
Pre: Naiant IPA v1.0
Recorders: M10, A10, TCD-D8
Transfers: Nakamichi CR-3A, Tascam DA-20

Online aaronji

  • Site Supporter
  • (8)
  • Needs to get out more...
  • *
  • Posts: 3079
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #5 on: November 14, 2020, 04:26:46 PM »
Mic-in, low sensitivity, should work pretty well (as  I recall, it is about 20 or 22 dB of gain compared to the line-in). With MK4s, you'd need to hit about 130 dBSPL before overloading the M10's input. As long as you don't have to set the gain knob below ~ 1.5 - 2 (see this post from DSatz), you won't brickwall. I would try that.
People whose posts I won't see: jerryfreak. The probationary period didn't last long...

Online DavidPuddy

  • (10)
  • Taperssection Member
  • ***
  • Posts: 810
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #6 on: November 14, 2020, 06:33:05 PM »
with 0dB gain you kinda need to use mic in

perhaps jon could mod your 0dB to +18dB fixed or something

his preamp circuit should be better than whatever the M10 uses

Honestly didn't think I could use mic in. Would be nice to have more room to work with and not have such problematic noise floor interference when there is quieter segments of a show.

Going to order the 2.0 IPA anyways. Will get some gain switches for that!

Has anyone actually received one of the 2.0 IPAs yet?
Mics: nbobs/480+ck61/62/63; C568EB; MKE2
Recorders: MP6; A10

Offline jerryfreak

  • (31)
  • Needs to get out more...
  • *****
  • Posts: 5455
  • The plural of anecdote is not data
Re: Record Levels With Schoeps/Naiant IPA Combo
« Reply #7 on: November 14, 2020, 08:44:17 PM »
i ordered one a long time ago, and havent gotten it because ive been too lazy to tell jon the final pin config i want. but he bugged me about it months ago. im sure somebodys gotten one by now
People whose posts I wont see:
 capnhook, daspyknows, Melanie, morst, Rob D., Scooter123, Sloan Simpson, Walstib62, Dr. Bickart

 

RSS | Mobile
Page created in 0.065 seconds with 36 queries.
© 2002-2020 Taperssection.com
Powered by SMF