Topic: ISO: DA-P1 wall wart

[chun]

Looking for a DA-P1 wall wart, would also consider chopped cable as well.

Thanks!

[jerryfreak]

easy to build

any reference on specs of input jack?

[Scooter123]

Looking for a DA-P1 wall wart, would also consider chopped cable as well.

Thanks!

You mean the AC Power supply?  Have you looked on eBay?  Most Tascam stuff is a standard diameter input, the large cylinder which I think is an "A" and either 7.5 or 12 volt input.  I did a quick and dirty search for "Power Supply 7.5 volts" and came up with quite a few under $15. 

[ero3030]

These have the goofy 3 pin plugs like the old Casio da2&7 so there is nothing off the shelf that can be used.  I'll dig around.  Like the Casio a lot of the OEM walwarts were bought to "hack" to make SLA battery packs.  Making them hard to find if at all new.  That was 90's stuff.   I'll look for ya, I may have one.  Ed

[chun]

Thanks Ed!

[jeenash]

I offered these cable ends up to another member but haven't heard back. 20$ for 1, 30$ for both, shipping included. They are factory molded ends that were used by ecocharge.

[ero3030]

Bingo!!