1/4 > 5/8 thread adapter

[jeromejello]

anyone know where i can get one of these cheap?  female 1/4" > male 5/8"

[Diamond_D]

did you try this one?

http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG

[caymanreview]

local camera shop?

[jeromejello]

did you try this one?

http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG

yeah, i tried but it was out of stock...

[Diamond_D]

did you try this one?

http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG

yeah, i tried but it was out of stock...

bummer! I remember seeing something like that at another place, I'll see if I can dig it up again...

[John R]

what i use

http://www.cascademedia.net/products.asp?catid=133&prodid=677

http://www.cascademedia.net/products.asp?catid=133&prodid=678

[jeromejello]

what i use

http://www.cascademedia.net/products.asp?catid=133&prodid=677

http://www.cascademedia.net/products.asp?catid=133&prodid=678

i almost went partially this route... i already have an extra 3/8 > 5/8... in the end, i just got hosed: 7.95 for the adapter, 8.25 to ship 

i dont even want to link the site... 

[1st set only]

do you care if it is permanent?
if not go to radioshack and get on of these....



http://www.radioshack.com/product.asp?catalog%5Fname=CTLG&category%5Fname=CTLG%5F007%5F002%5F013%5F000&product%5Fid=33%2D372

if the link dont work its Catalog # is 33-372

just epoxy the metal male 5/8 sleeve to the top of your mic stand. make sure you put tape around the threads when you are epoxying.

[jeromejello]

i need the top of the stand to have 5/8 male threads so i can screw on the at8410a.

thanks for the tip tho!

[jeromejello]

what i use

http://www.cascademedia.net/products.asp?catid=133&prodid=677

http://www.cascademedia.net/products.asp?catid=133&prodid=678

i almost went partially this route... i already have an extra 3/8 > 5/8... in the end, i just got hosed: 7.95 for the adapter, 8.25 to ship 

i dont even want to link the site... 

and if that wasnt bad enough, now they are claiming to be backordered!  muthafucka!

still looking...

(btw, cascade media is in the middle of switching offices... just not a good time i guess)

[Billy Mumphrey]

i need the top of the stand to have 5/8 male threads so i can screw on the at8410a.

thanks for the tip tho!

check this out

http://taperssection.com/index.php?topic=25474.0

[jeromejello]

thanks... but i found a 1/4 > 3/8 bogen adapter at a camera shop locally and then just used the extra 3/8 > 5/8 adapter that i had.

problem solved.