5/8 Male > 5/8 Male Coupler

[Rick]

Anyone know where to get one of these? If it exsist!


To make a long story short, I have 2 MBHO active clips that I want connect via the Coupler to add some space between the caps

Rick

[nickgregory]

get the rapido quick connect...check out sonic sense website under stand accessories

[nickgregory]

see here for another retailer and details

http://www.taperssection.com/yabbse/index.php?board=14;action=display;threadid=2499

[Rick]

Looks like 5/8 Female > 5/8 Male. I'm I wrong?

[nickgregory]

your right...was not paying attention...sorry about that

[goose]

Hey Rick -

I knew I had seen one before...

try

http://www.tensimount.com/ordering.htm  --  look at "Li'l Stubby"

:afro:
goose

[Rick]

That would work, but something a little longer would be nice. But it might be my only option.

Any chance they make 1' boom poles

[Brian Skalinder]

When I ran MBHOs I used a dowel rod - inserted both ends of the rod into the mic clips, then taped 'em up.  Worked great, if a little ghetto.

[goose]

Can't you just throw a Rapid adapter or Atlas Lo2B on each end of the L'il Stubby and have what you want?

[Rick]

ghetto

I was thinking about tring the Bogan Mini Boom. (http://www.bhphotovideo.com/product/5195/BO2944/REG/1375) I could get a nice little 3 and Half foot spread going. But then I would have to get some adaptors and I want to put it through a single Schoeps Shockmount and I'm not sure if that would work...

[Rick]

Can't you just throw a Rapid adapter or Atlas Lo2B on each end of the L'il Stubby and have what you want?

That might work.

[smanky]

see here for another retailer and details

http://www.taperssection.com/yabbse/index.php?board=14;action=display;threadid=2499

ok this has nothing to do with the topic, but re: that thread you linked to, for X-Y is it better to run one facing up and one facing down, or better to try and get a smaller vertical distance between the mics by building a riser?