Become a Site Supporter and Never see Ads again!

Author Topic: Berliner CM-33 mics?  (Read 49790 times)

0 Members and 1 Guest are viewing this topic.

Offline jbell

  • TDS
  • Trade Count: (149)
  • Needs to get out more...
  • *****
  • Posts: 4567
  • Gender: Male
  • Spreadicated
Re: Berliner CM-33 mics?
« Reply #90 on: July 13, 2017, 05:27:32 PM »
Mics: DPA ST4011ER & 4018ER
Preamps: DPA MMA 6000 | Audioroot Femto
Recorders: Sound Devices Mixpre-10 II | Sony PCM A10

-20        -12         -6        TDS   (32/48)     
]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]][}   
]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]][} 
__________________________
|Record|  Runtime: 4:19.99  {|||] 75%

Offline acidjack

  • Site Supporter
  • Trade Count: (37)
  • Needs to get out more...
  • *
  • Posts: 5845
  • Gender: Male
Mics: Schoeps MK4V, MK41V, MK5, MK22> CMC6, KCY 250/5, KC5, NBob; MBHO MBP603/KA200N, AT 3031, DPA 4061 w/ d:vice, Naiant X-X, AT 853c, shotgun, Nak300
Pres/Power: Aerco MP2, tinybox v2  [KCY], CA-UBB
Decks: Sound Devices MixPre 6, Zoom F8, M10, D50

My recordings on nyctaper.com: http://www.nyctaper.com/?tag=acidjack | LMA: http://www.archive.org/bookmarks/acidjack | twitter: http://www.twitter.com/acidjacknyc | Soundcloud: https://soundcloud.com/acidjacknyc

Offline hoppedup

  • Trade Count: (17)
  • Needs to get out more...
  • *****
  • Posts: 3349
  • Sa da tay!
Re: Berliner CM-33 mics?
« Reply #92 on: July 14, 2017, 08:24:44 AM »
They come with mounts. I've used this bar with them: https://www.bhphotovideo.com/c/product/534727-REG/K_M_23550_500_55_23550_Adjustable_Microphone_Bar.html

The mic bodies are short enough that you don't need to offset them in height for most stereo configurations.

I have been exclusively pointing at stacks (PAS) with roughly 17-20cm spread for the last few years. I will say that shapeways mount is pretty sexy, though.

I'm currently using this mount with my akg391s (same diameter) and I love it: https://www.bhphotovideo.com/c/product/894262-REG/rycote_041125_in_vision_stereo_pair.html
AKG SE300B CK91
JB Mod NAK 300 CP1 - CP2

Tascam DR-40, Tascam DR-60D, Tascam DR-22WL, Marantz PMD-706
Panasonic Lumix DMC-G7K

↑↑↓↓←→←→ BA Start
         


My recordings on bt.etree
  
My recordings on LMA

Offline Nick's Picks

  • Trade Count: (33)
  • Needs to get out more...
  • *****
  • Posts: 10260
  • Gender: Male
  • I thought I heard.......
Re: Berliner CM-33 mics?
« Reply #93 on: July 14, 2017, 08:27:09 AM »
http://www.rode.com/accessories/sb20
this is my favorite bar.  has measurements and angles setup for ORTF and XY/DIN

jcable77

  • Guest
  • Trade Count: (0)
Re: Berliner CM-33 mics?
« Reply #94 on: July 14, 2017, 05:26:00 PM »
Have Scott make you a DIN mount! 

https://www.shapeways.com/product/Z5PW7SVQZ/din-berliner-cm33?optionId=56698034
Winner  :clapping:
This is the best idea for these. The stock mounts for them, the threading was a bit chinsey I thought. I still use the shapeways din for other mics.

Offline dynamicalories

  • Trade Count: (7)
  • Taperssection Member
  • ***
  • Posts: 355
Re: Berliner CM-33 mics?
« Reply #95 on: July 15, 2017, 01:41:29 PM »
Just FYI: If you get the shapeways mounts, you might ask him if he can elongate the stem so you can use it with the Rycote INV-HG III mount.

Offline detroit lightning

  • Trade Count: (10)
  • Taperssection Member
  • ***
  • Posts: 772
Re: Berliner CM-33 mics?
« Reply #96 on: July 18, 2017, 07:29:45 PM »
http://www.rode.com/accessories/sb20
this is my favorite bar.  has measurements and angles setup for ORTF and XY/DIN

All good ideas - thanks for the feedback. I went with this one mainly for ease of use...got it today, and it seems like what I was looking for.

How are the included windscreens with these? If I'm going to be taping outside will these do well enough, or should I invest in some dead rats for these (or maybe my CA14 rats might even fit?)

Should be able to give these a go this sunday for Tedeschi Trucks...and run a second source on my new (to me) R26!

Offline opsopcopolis

  • Trade Count: (3)
  • Needs to get out more...
  • *****
  • Posts: 2144
Re: Berliner CM-33 mics?
« Reply #97 on: August 07, 2017, 09:06:35 AM »
Definitely get rats.

Offline detroit lightning

  • Trade Count: (10)
  • Taperssection Member
  • ***
  • Posts: 772
Re: Berliner CM-33 mics?
« Reply #98 on: August 07, 2017, 09:48:45 AM »
Definitely get rats.

Yeah, found that out the hard way @ TT...those windscreens didn't do a whole lot. Doubt I will use these a ton outdoors though...

Offline opsopcopolis

  • Trade Count: (3)
  • Needs to get out more...
  • *****
  • Posts: 2144
Re: Berliner CM-33 mics?
« Reply #99 on: August 07, 2017, 10:50:26 AM »
Definitely get rats.

Yeah, found that out the hard way @ TT...those windscreens didn't do a whole lot. Doubt I will use these a ton outdoors though...

I did too with my CM33s... I even use the rats inside sometimes.

Offline Twenty8

  • Trade Count: (13)
  • Taperssection Member
  • ***
  • Posts: 482
  • Heading for a better thesis
Re: Berliner CM-33 mics?
« Reply #100 on: February 09, 2019, 01:48:31 PM »
Is there a website with specs on this mic?
Found this, but it does not include its diameter:
Quote
Directional Pattern:     Cardioid
Acoustical Operating Principle:          Pressure gradient transducer
Active Electronics:      Transformerless FET
Frequency Response:  20Hz - 20 kHz
Sensitivity:      -40dB (9mv/Pa 0dB=1V/Pa at 1 KHz)
Level Attenuation:      10dB (switchable)
Low-Cut filter:            3dB/Oct. at 120Hz (switchable)
Rated Impedance:       50 ohms
Maximum SPL:           141dB (@1kHz, 0.5% THD) 151 dB SPL with -10dB pad
Equivalent Noise:        22dB-A
S/N Ratio:       76.3dB
Power Requirement:   48 +/- 4V, 3mA
Circuit:            FET driven, discrete balanced output
Connection:     gold-plated balanced 3 pin XLR
« Last Edit: February 09, 2019, 01:54:27 PM by Twenty8 »
Open/Closed ~ AT U853 (subc, h, c, o):
Decks ~ MixPre 6ii, A10, M10
Pres ~ 2x Oade mod UA-5 (W+, ACM+)
Also ~ Line Audio CM3/CM4/OM1 : AT3031 : AT831 : DR2D

jcable77

  • Guest
  • Trade Count: (0)
Re: Berliner CM-33 mics?
« Reply #101 on: February 09, 2019, 02:33:09 PM »
Im pretty sure they are 19-20mm. Not much info as The company fell off the map. Good sounding mics for the price. Kind of wish I still had em.

Offline Twenty8

  • Trade Count: (13)
  • Taperssection Member
  • ***
  • Posts: 482
  • Heading for a better thesis
Re: Berliner CM-33 mics?
« Reply #102 on: July 20, 2019, 05:41:27 PM »
Wondering if anyone has a SRS mount that fit these mics.
No available model on the SRS website.  Maybe someone here has used one successfully that was made for a different set of mics?

Just bought a pair of these mics.
Open/Closed ~ AT U853 (subc, h, c, o):
Decks ~ MixPre 6ii, A10, M10
Pres ~ 2x Oade mod UA-5 (W+, ACM+)
Also ~ Line Audio CM3/CM4/OM1 : AT3031 : AT831 : DR2D

jcable77

  • Guest
  • Trade Count: (0)
Re: Berliner CM-33 mics?
« Reply #103 on: July 20, 2019, 08:12:56 PM »
Wondering if anyone has a SRS mount that fit these mics.
No available model on the SRS website.  Maybe someone here has used one successfully that was made for a different set of mics?

Just bought a pair of these mics.
Look at neumann km184 SRS mounts. Same size pretty much

Offline goodcooker

  • Trade Count: (43)
  • Needs to get out more...
  • *****
  • Posts: 4638
  • Gender: Male
  • goes to 11
Re: Berliner CM-33 mics?
« Reply #104 on: July 20, 2019, 08:18:41 PM »
Wondering if anyone has a SRS mount that fit these mics.
No available model on the SRS website.  Maybe someone here has used one successfully that was made for a different set of mics?

Just bought a pair of these mics.

I didn't use the SRS mounts when I had a pair of these so I'm really no help. Just chiming in to say that I'm in New Orleans so we should get together some time.  :cheers:
Line Audio CM3/OM1 || MBHO KA500 hyper>PFA|| ADK A51 type IV || AKG C522XY
Oade Warm Mod and Presence+ Mod UA5s || Aerco MP2(needs help) || Neve Portico 5012 || Apogee MMP
SD Mixpre6 || Oade Concert Mod DR100mkii

pocket sized - CA11 cards > SP SB10 > Sony PCM A10

http://www.archive.org/bookmarks/goodcooker

"Are you the Zman?" - fan at Panic 10-08-10 Kansas City
"I don't know who left this perfectly good inflatable wook doll here, but if I'm blowing her up, I'm keeping her." -  hoppedup

 

RSS | Mobile
Page created in 0.148 seconds with 44 queries.
© 2002-2024 Taperssection.com
Powered by SMF