Become a Site Supporter and Never see Ads again!
Previous topic - Next topic
Pages: Pages1   Go Down

Author Topic: HD-P2 + DPA 4061  (Read 4,074 times)

0 Members and 1 Guest are viewing this topic.

Offline mikejk

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 10
HD-P2 + DPA 4061
« on: August 31, 2007, 04:26:58 PM »


Hi !

My next equipment will be a HD-P2 Tascam unit and a pair of DPA 4061 mics.    
I wonder if it's worth buyin' a pre-amp, not really cheap, as MMA6000, or
i could obtain a good powered signal with this set

Thanks
Logged

Offline JasonSobel

  • Trade Count: (8)
  • Needs to get out more...
  • *****
  • Posts: 3,324
    • My show list
Re: HD-P2 + DPA 4061
« Reply #1 on: August 31, 2007, 05:31:52 PM »
the 4061's don't take phantom power, right? (someone please correct me if I'm wrong)
the HD-P2 only supplies phantom power, so, at the very least, you'll need a battery box to power the mics.
maybe it'll be worthwhile to get an outboard pre-amp (instead of just a battery box), but maybe not.
Logged

Offline Craig T

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 4,273
    • LMA
Re: HD-P2 + DPA 4061
« Reply #2 on: August 31, 2007, 05:59:40 PM »
You can get microdot>xlr adaptors that will allow powering via phantom power from the recorder (or preamp) - the DAD6001's.  I used to run 4061's> DAD6001> V2/V3 this way.  Worked just like any other mic, no problem getting good levels with average gain.

Quote from: JasonSobel on August 31, 2007, 05:31:52 PM
the 4061's don't take phantom power, right? (someone please correct me if I'm wrong)
the HD-P2 only supplies phantom power, so, at the very least, you'll need a battery box to power the mics.
maybe it'll be worthwhile to get an outboard pre-amp (instead of just a battery box), but maybe not.
Logged
Schoeps cmc6/4v / Beyer mc950 / Line Audio CM3, OM1 / ADK A51 / Church Audio CA-14
Naiant Tinybox v2.2 / NBox(P) / Church Audio ST9200 / CA-UGLY
Sony PCM-M10 / Zoom F3 / Zoom F6

Offline mikejk

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 10
Re: HD-P2 + DPA 4061
« Reply #3 on: August 31, 2007, 06:16:58 PM »

  The DPA SMK4061 is an stereo kit that has two hand-matched 4061 omni
  microphones, along with microdot to XLR adapters that allow the mics to receive
  +48v phantom power
Logged
Pages: Pages1   Go Up
Previous topic - Next topic
 

RSS | Mobile
Page created in 0.053 seconds with 27 queries.
© 2002-2026 Taperssection.com
Powered by SMF