Yeah, but what is fine? I find that I need to check voltage w/ DMM to minimize battery waste. The louder the show the more important it is to have no less than 8v or so.... At lower than that, i found that you get distortion on the low end. I hate 9 volt batteries.
I see, I don't really recall its been awhile
Try to support my mics by the cable ends do not have them resting on a hard surface because you can end up with vibration that is picked up and reproduced by the microphone as distortion
You should use tape on the heat shrink side of the mics so that they are sticking out from your clamps.. Or build a elastic shock mount
Don't forget to give me the plans
I have an idea on how to build one but it involves castration bands.....
Also when using my omni mics you must back off on the gain just a tad to say 75% instead of 100% because my omni mics are hotter then my cards.